July 3rd

Set up most of below canopy site
DAFS- working fine

jNO2 (UH)- was noisy in "differential" mode on Labjack UE9-Pro. Much better after putting shield cable to ground. Need to fix Above Canopy jNO2 instrument wiring to UE9-Pro.

SkyCam-Not working. Took apart USB extender and cloud cam. Then figured out bad power supply. Purchased new 6V ps from radio shack. Will rewire tomorrow. Power was fluctuating one and off. Could be a short. USB extender works fine. Have Below Canopy skycam connected to SAFS pc, which is the SO2 pc for the time being.

UV array-Set up 4 UV sensor array around OH inlet.
ACD-24 YJE15/33 Pico Data logger
Sensor 1405 in NE corner, ch 1-2 diff (multiplier 6.55)
Sensor 1406 in SE corner, ch 3-4 diff (multiplier 6.37)
Sensor 1407 in SW corner, ch 5-6 diff (multiplier 6.55)
Sensor 1414 in NW corner, ch 9-10 diff (multiplier 6.83)
Data recorded on Toughbook
VNC to toughbook 198.110.84.219
pw: array_pt
Using pico software and real pain. Not sure best way to operate. Need to ask Nicole.
Reoved sensor 1413 from array because very noisy. Much more than all other senors.

SO2 report- instrument seems to be running fine. Logging to safs pc since registry on so2 pc is messed up. Will not allow some programs to run. But main problem is VNC does not work most of the time. Some permissions problem. Need to have Ryan re-install WinXP-Pro. But need to copy off data first.

Tomorrow and the day after--
Set up TSI
Repair Cloud Cam
Set up 5 more uv sensors below canopy
Start working on SAFS
Re-wire above canopy jNO2 signal wires to midcanopy UE9-pro in grey box#1
Setup below canopy direct diffuse instrument
Clean up lab space
Transport empty shipping cases to cargo storage space.